Panel Guide

Aritech Advisor Advanced – Dial Capture

Panel Connection – Dial Capture

Manufacturer	Carrier
Model	Aritech ATS Advanced
Cable required?	MCM connected to: DualCom Pro 1 – MCM plug-on module CS.1.402 DualCom Pro 2 – DI & AL
Panel Profile	ARITECH-ADVANCED-MCM
Panel Bus Connection	Dial Capture
Technical Notes	To enter engineer mode, access must be allowed via a setting in User mode. After defaulting the panel, the panel will ask questions on power up. User Code : Menu 8:2:1 – Need Acc [YES] Eng Code : Menu 8: Sys Opt > 7: Panel & AB Opts > 9: Remote Config – YES

Panel Connection Information

DualCom Pro 1 – MCM plug-on module – Line A DualCom Pro 2 – DI	PSTN A
DualCom Pro 1 – MCM plug-on module – Line B DualCom Pro 2 – AL	PSTN B

Panel Programming

Enter : Installer Mode (Engineer)
Select: 9>Dialler menu
Enter: 1> CS
Enter: 01> CS 1
Set: CS name [CS 1]
Enter: 2>‘Transm Path’ [PSTN]
Enter 3>‘Protocol’
Set: (X)SIA’
Enter 4>Phone [01234567890]
Enter 5>‘Accounts’ menu
Select: ‘Area ‘1’ with [account numbers]
Select: ‘Area ‘2’ with [account numbers OR blank]
Select: ‘Area ‘3’ with [account numbers OR blank]
Select: ‘Area ‘4’ with [account numbers OR blank]
Enter 6>‘Mode’
Set: Primary CS’
Enter 7> retry count [10]
Enter 8>‘Protocol opt’
Set: ‘(X)SIA’
Set ‘Area Modifier’ to ‘[ON]’
Set ‘Name Chars’ to ‘[30]’
Set ‘Event Number’ to ‘[3 digits]’
Set ‘Subev codeing’ to ‘[Decimal]’
Set ‘SIA Frequency’ to ‘[Bell]’
Go back to ‘Dialler’ menu level
Enter 3>‘Path Options’
Enter 1>‘PSTN’
Enter 2>‘Line Fault’ menu and select option ‘[No]’
Go back to ‘Path Options’ menu level.
Enter 4>IP (If present)
Enter ‘Line Fault’ menu and select option ‘[No]’
Enter 4>‘PC Conn’ menu
Select 1>‘PC Conn 1’
Set 2>‘Trans Path’ to ‘PSTN’
Set 3>‘Modem Protocol’ to ‘V22’
Set 4>‘Phone Number’ to ‘None’ or blank
Set 5>‘Retry Timeout’ to ‘3’
Set 2>‘PC Callback’ to ‘Off’
Set 3>‘Encrypt Key 1’ as required
Set 4>‘Encrypt Key 2’ as required
Set 5>‘Listening Port’ to ‘n/a or None’
Set 6>‘Panel ID’ to ‘None’
Enter ‘Path Options’ menu
Enter ‘PSTN’
Set ‘Name’ to ‘PSTN’
Set ‘Line Fault’ as required
Set ‘Line Fault Delay’ to ‘0’
Set ‘Transmission Path’ to ‘PSTN’
Set ‘Dial Tone’ to ‘UK’
Set ‘Dialling’ to ‘DTMF’
Set ‘Ring Count’ to ‘1’
Set ‘Encryption’ to ‘No’
Exit Installer / Engineer Mode
Note: This may require a full panel and DualCom Pro reboot.