Scantronic i-on 2 – TTL

Panel Connection – TTL

Manufacturer	Eaton
Model	Scantronic/Menvier
Version	I-ON (10, 16, 30, 100)
Minimum Panel Firmware	MIN – V4:03
Cable required?	Standard alarm cable
Panel Profile	Panel firmware less than or equal to v5 use scantronic-ionprev6-ttl Panel firmware greater than or equal to v6 use scantronic-ionpostv6-ttl
Panel Bus Connection	TTL
Technical Notes	For SIA and UDL CS.1.403 Scantronic I-ON plug on board is required. Please note Scantronic I-ON 20 EX panel does not support this TTL integration but will integrate via Dail Capture.

Panel Connection Information

SPT	Serial Board
TTL-T	R
TTL-R	T
RTN	RTN

Panel Programming

To configure the panel, the DualCom Pro must be fully configured, wired to the panel and
rebooted. This causes the panel to query all devices connected and make various menu options
available in the keypad and in the web browser
Panel Communication on initial setup
Access the panel as an Installer
In the “Installer” menu navigate to the “Communications” menu > navigate to the “Contacts”
menu > find an unused [Recipient] and rename to ‘DualCom Pro’
Enter ‘0123456789’ in the [Tel No 1] field > Enter ‘127.0.0.1’ in the [IP Address] field
Navigate out of “”C” > Navigate to “ARC Reporting” and set “Call Mode” to “Single”
Set “Telecoms Priority” to “Module: Ethernet 1”
In “Recipients” menu, clear out “Tel. Recipient 1” and “Tel. Recipient 2” and “IP Recipient 2”
Set “IP Recipient 1” with ‘DualCom Pro’
Navigate out of “Recipients”
Add the account number to “Account Numbers”
Set “Report Type” to ‘SC SIA 3’
In [CID/SIA Events] enable your choice of events to report
Set [Restorals] to ‘Enabled’
Set [Unset Comms] to ‘Enabled’
Navigate to [IP Network (Own)] and [Module: Ethernet]
Set [IP Address] to ‘127.0.0.1’
Set [IP Subnet Mask] to ‘255.255.255.0’
Set [Gateway Address] to ‘127.0.0.1’
Navigate out of [IP Network (Own)]
Navigate to “Downloading” menu
In “Account” menu set [Name] and [Serial Number]
In [Downloading] set [Access Mode] to ‘Unattended’
In [IP Network] set [IP Address] to ‘127.0.0.1’ and clear out all other IP addresses 2
In [Remote Servicing] set [Enable Service] to ‘Enabled’
Exit Installer-Engineer mode