Texecom – Premier & Elite UDL Guide

• Place the Texecom panel in engineer mode
• Connect the aerial provided to the DualCom
• Connect the DualCom directly to the COM 2400 board via the “to panel digi” port on the DualCom
• The DualCom will go through its power-up/registration process, which will take approximately 2-3 minutes
• The top “SVC” LED will start to pulse like a heartbeat once locked onto the network
• The signal strength will then be displayed
• Leave the DualCom to conduct an internal network survey – this will happen automatically. The display will show 0.0, 0.1, 0.2, etc
• Once the survey is complete, you then need to proceed to panel programming
• If triggered inputs on the DualCom are being utilised in fast format, then proceed to “Panel Programming (UDL)”
• Panel Programming (SIA)
• Enter the engineering menu
• Press the down arrow until you reach “UDL/Digi Options”, then press YES
• Press the down arrow until you reach “Program Digi”, then press YES
• The display shows “ARC 1 Protocol Disabled”. Press NO and then the down arrow until “SIA Level II” is displayed
• Press YES, then YES again, and the display shows “Primary No”. Press NO and enter number 01, followed by YES
• Press down arrow once to “Secondary No”, then press NO and enter number 01 followed by YES
• Press YES until “Account Number” is displayed, press NO, then enter the DualCom’s chip number followed by YES
• Press down arrow to “Config (* * * * * * * *)”, press NO then down arrow until Send SIA Text is displayed, press NO, and the display will now show “Send SIA Text (* * * * * * * T)”, press YES
• Press menu then down arrow until “Digi Options” is displayed, press YES
• “Digi Options (* * * * * *)” is displayed, press NO twice
• Display will now show “Digi is Enabled (E * * * * *)”, press YES
• Unit is now set up to send SIA to the ARC via the dial capture ports

(Note if you have completed SIA programming then skip to point 5)

• From engineering menu press down arrow until you reach “UDL/Digi Options”, press YES
• Press down arrow until “Digi Options” is displayed, press YES
• “Digi Options (* * * * * *)” is displayed, press NO twice
• Display will now show “Digi is Enabled (E * * * * *) press YES then menu
• Press down arrow until you reach “UDL Options” press YES
• Press down arrow until you reach “UDL Password” factory default is 1234, this is optional if you wish to change then press NO and enter your password followed by YES
• Press down arrow until “UDL Options (* *MD * * *) is displayed ? The “D” needs removing, press NO then number 3, display now should show (**M****), press YES
• Press down arrow until “Rings Required” is displayed, factory default is “005” press NO and change to 001, press YES
• Press menu followed by down arrow to “Setup Modules” press YES
• Press down arrow until “Modem Speed” is displayed. Ensure this is set to 2400, if not press NO until 2400 is displayed then press YES
• Press menu followed by the down arrow until “Com Port Setup” is displayed, press YES
• “Onboard Digicom (Com300 Module)” is now displayed, press NO then down arrow until “Com2400 Module” is displayed, press YES
• Unit is now setup for UDL

• Make a note of the panel’s Make, Model and Version e.g. Elite, 48, version x2
• This information is critical when setting up a file in Wintex from where ever your UDL connection is being made from.