Panel Connection – Dial Capture
| Manufacturer | Carrier - Interlogix |
| Model | Networx |
| Version | N/A |
| Minimum Panel Firmware | N/A |
| Cable required? |
MCM connected to
|
| Panel Profile | INTERLOGIX-NETWORK-MCM |
| Panel Bus Connection | Dial Capture |
Panel Connection Information
| DualCom Pro 1 - MCM plug-on module - Line A DualCom Pro 2 - DI |
PSTN Line T |
| DualCom Pro 1 - MCM plug-on module - Line B DualCom Pro 2 - AL |
PSTN Line R |
Panel Programming
To access the panel for configuring, press keypad keys *8 then Installer code
- Keypad will display [Enter the device address then #]
- Then press 0 and # to select the panel.
- Keypad will display [Enter the feature no., then #]
Press 4 then # to select Phone Number One
- Keypad will display [Loc# .0 Seg# 1].
- Input the telephone number 0123456789 by pressing one digit and the * for each of the numbers in the telephone number then press #
- Keypad will display [Enter the feature no., then #]
Press 5 then # to select System Account Code
- Keypad will display [Loc#. 1 Seg# 1].
- Input the account number by pressing one digit and the * for each of the numbers in the account number then press #
- Keypad will display [Enter the feature no., then #]
Press 6 then # to select Communicator Format
- Keypad will display [Loc#. 2 Seg# 1].
- Input 1 and *
- Keypad will display [Enter the feature no., then #]
Note: Clear settingvalue for all other Telephone Number features
Press 12 then # to select Download Access Code
- Keypad will display [Loc. 19 Seg# 1].
- Make a record of or input the download access code that must match what is entered or stored in the DL900 configuration (UDL) program.
- Keypad will display [Enter the feature no., then #]
Press 13 then # to select Number of Rings/Number of Calls to Answer
- Keypad will display [LOC #. 20 Seg# 1].
- Input 1 and * then 0 and *
- Keypad will display [Enter the feature no., then #]
Press 14 then # to select Download Control
- Keypad will display [Loc#. 21 Seg# 1].
- Input 1 to 8 so that no numbers are displayed and only '_' are shown. Press #
- Keypad will display [Enter the feature no., then #]