Panel Connection – RS232

Panel Connection Information

Panel Programming

• Login to Engineer Mode, exit/Menu Button, press Engineer Code and press OK
• [Keypad shows 1] Programming and press OK
• [Scroll to 1] System and press OK
• [Scroll ↓ to 2] Controls and press OK
• [Scroll ↓↓ to 3] Communication and press OK
• [Scroll ↓↓ to ARC ENABLE] and set to 'N' and press OK
• [Screen shows 3] Communication and press OK
• [Scroll ↓ to FM] Enable and set to 'N' and press OK
• [Screen shows 3] Communication and press OK
• [Scroll ↓↓ to CS ENABLE] and set to 'Y' and press OK
• Press Exit/Menu Button 2 twice you are now in the Main Menu
• [Scroll ↓↓↓ to 5] Communications and press OK
• [Scroll ↓ to 3] Config. SW and press OK
• [Screen shows 1] Security and press OK
• [Scroll ↓ to 2] Remote ID and press OK
• Modify value to 00000 and press OK
• [Screen shows 2] Remote ID Press Exit/Menu Button press ↓
• [Screen shows 2] Call Back. Press OK and ensure NO PHONE NUMBERS are set
• Press Exit/Menu Button x 4 times
• [Screen shows 5] Communication
• Now Exit/Engineer Mode 0 and press OK, this will save the data

Troubleshooting

• NOTE: RISCO LightSYS has two communication menus, please check you are in the correct
  Communication Menu during panel programming.
• Ensure upon initial panel start up that the language selection is used otherwise ARC Enable will
  not show under Communications Menu 3.
• To amend this, go to [Programming][System][Settings][Customer] and change it from ‘0EN’ to
  ‘0UK’ (as it should be for us in the UK).
• By doing this, they will forfeit the entire programming as the panel will invoke a full default for
  ‘UK’ settings.
• NOTE: Panel integration only supports non-zone type alarms such as BV (Burglary Verified) on the following – DualCom Pro V2.25 & up and DualCom Pro 2 all FW versions